All Collections
Admin Settings
Introduction to Settings
Managing your Location Settings across WeTrack
Managing your Location Settings across WeTrack

Location Manager

Leoni Keogh avatar
Written by Leoni Keogh
Updated over a week ago

WeTrack's incident management and event control system is underpinned by location mapping. Admin users can set up zones and areas in the ‘Location Manager’, found by clicking on your avatar in the bottom left-hand corner of any WeTrack page and navigating to Settings.

Now, Projects, Tasks, Risks, Readiness Capabilities and Activities, and other items in the WeTrack system can also have locations; the locations that you set up in the Location Manager can be used across the whole system.

In Location Manager, you can set up zones, and within each zone, areas, that can then be identified when an incident takes place. Here is also where you set up the dashboard weather location, a forecast for which will be displayed on your incident dashboard.

Start off by adding a zone. Click 'Add', draw the zone on using the map tool, enter a title, and save. To find a specific location, use the search function in the top left-hand corner of the map, and to draw on the zone, use the draw function at the bottom of the map.

You can then add areas to a zone by selecting it from the list, clicking 'Add Area', and following the same creation steps.

When you then add new items in the WeTrack system, you will be able to select these pre-drawn zones and areas, as well as using the search function to select any other location.

Did this answer your question?